电加热控温鼓风干燥箱的实际操作

电热培养箱：电热恒温鼓风干燥箱应该怎么使用呢？操作方法是什么呢？下面，我们一起了解一下吧!

Electrothermal incubator: How should the electrothermal constant temperature blast dryer be used? What is the method of operation? Next, let's solve it together.

1、干燥箱内严禁放入易燃、易挥发物品，以防爆炸。

1. Flammable and volatile substances are strictly prohibited in the drying box to prevent explosion.

2、用专用的插头插座，并用比电源线粗一倍之导线接地。使用前检查电气绝缘性能，并注意有否断路、短路及漏电现象。

2. Use special plugs and sockets and grounding with conductors twice as thick as power lines. Check the electrical insulation performance before use, and pay attention to whether there are open circuit, short circuit and leakage phenomenon.

3、箱上放入温度计，打开电源调节温控旋钮到设定温度，至交流接触开关刚好断开时检查温度计的读数与设定值是否相符，如果有出入则进行微调，直至恒温温度符合设置温度。

3. Put a thermometer on the box, turn on the power supply to adjust the temperature control knob to the set temperature, check whether the thermometer reading is consistent with the set value when the AC contact switch is just disconnected, and fine-tune if there is any discrepancy, until the constant temperature meets the set temperature.

4、打开顶部或底部排气孔排除箱内湿气。

4. Open the top or bottom vents to remove moisture from the box.

5、试品钢板更大平均负荷为15Kg，放置切勿过重、过密，一定要留有空隙，工作室底板上不能放置试品。

5. The average load of the test plate is 15 Kg. Do not place it too heavy or too close. There must be a gap. The test plate can not be placed on the floor of the studio.

6、通上电源，绿色指示灯亮，开启鼓风开关，鼓风电机运转，开启加热电源，干燥箱即进入工作状态。

6. Turn on the power supply, turn on the green light, turn on the blower switch, turn on the blower motor, turn on the heating power supply, and the drying box will enter the working state.

7、工作时，箱门不宜经常打开，以免影响恒温场。

7. When working, the door should not be opened frequently to avoid affecting the constant temperature field.

以上就是电热培养箱厂家给大家带来的资讯介绍，了解更多的相关知识介绍，欢迎关注我们的官方网站。

Above is the introduction of information brought to you by the manufacturers of electric heating incubators, to learn more about the introduction of relevant knowledge, welcome to pay attention to our official website.

http://www.crxyq.cn