电热培养箱要留意的11个难题

使用电热培养箱要注意的问题主要有11个，下面让电热培养箱厂家带大家了解一下。

There are 11 main problems to be noticed when using the electric heating incubator. Let the manufacturers of the electric heating incubator take you to know.

1、非必要时，不得打开温度控制仪以防损坏。

1. When not necessary, do not open the temperature controller to prevent damage.

2、长期不使用时，应切断电源，严禁各处液体进入机内，以免损坏主机。

2. When not in use for a long time, the power supply should be cut off, and the liquid from all places should be strictly prohibited from entering the machine, so as to avoid damaging the main engine.

3、切勿把本机箱体放在含酸、含碱的腐蚀环境中，以免破环电子部件。

3. Do not place the case in the corrosive environment containing acid and alkali, so as not to break the ring electronic components.

4、在通电使用时，切忌用手接触及箱左侧空间的电器部份或用湿布揩抹及用水冲洗。

4. Do not touch the electrical parts on the left side of the box by hand or wipe them with wet cloth or rinse them with water when using electricity.

5、熔丝管装于箱内左侧空间内，调换时需要打开边门，并必须切断电源。

5. The fuse pipe is packed in the left space of the box. When changing, the side door should be opened and the power supply must be cut off.

6、电源线不可缠绕在金属物上，不可放置在高温或潮湿的地方，防止橡胶老化以致漏电。

6. The power cord should not be wound on metal objects. It should not be placed in high temperature or humid places to prevent rubber from aging and leakage.

7、每次使用完毕后，须将电源切断。经常保持箱内外清洁和水箱内水的清洁。

7. After each use, the power supply must be cut off. Always keep the inside and outside of the tank clean and the water inside the tank clean.

8、当使用温度较高时，应注意小心烫伤。

8. When using at a higher temperature, care should be taken for scalds.

9、注意保护电热恒温培养箱箱体漆面影响箱体外形美观。

9. Attention should be paid to the protection of the paint surface of the incubator, which affects the appearance of the incubator.

10、本箱为不防爆型，故腐蚀性及易燃性物品禁止放入箱内。

10. This box is non-explosion-proof, so corrosive and flammable articles are prohibited to be put into the box.

11、试验物放置在箱内不宜过挤，使空气流动畅通，保持箱内受热均匀，内室底板靠近电热器，故不宜放置试验物。在实验室，应将风顶活门适当旋开，以利调节箱内温度。

11. The test material should not be placed in the box to make the air flow smoothly, keep the heat uniform in the box, and the bottom of the inner chamber is close to the electric heater, so it is not suitable to place the test material. In the laboratory, the top valve should be properly switched to facilitate the adjustment of temperature in the box.

http://www.crxyq.cn